HTR logo

office (281) 376-8950
fax (281) 376-8476
sales@htr-tx.com


YUASA HOLLOW SPINDLE OIL COUNTRY LATHE

Specifications:
Serial number                                                        None located
Pendant control                                                     Yes
Swing over bed                                                     36”
Swing over cross slide                                          24”
Center distance                                                    90”
Bed width                                                              25.5”
Spindle bore                                                         9.5”
Chucks                                                                   24" 4 Jaw chuck, 12" ID
                                                                               20” 3-jaw with 6” bore Rear mounted
Spindle speeds                                                    10-350 rpm, 12 steps
Taper attachment                                                 Yes, but not bar or taper clamp.
Threading                                                             Yes, Inch, Metric, Module, Whitworth
Tailstock                                                               Yes
Steady rest                                                           No
Coolant                                                                 Yes
Electrical disconnect                                            Yes
Main motor                                                           18.5 Kw/25 hp.
Dimensions                                                          18’ W x 6’ 5” L x 7 5” H
Weight                                                                  18,000 lbs. estimated

Price: $ 32,000. FOB Houston, TX. Subject to Prior Sale.

Comments: This is an older lathe (probably out of the late 70’es or early 80’es) in no better
than average condition. Everything on it seems to be working. We have replaced a number
of bearings in the carriage and repaired all of the lube lines plus numerous other minor
repairs. This lathe was previously used for drill bit resurfacing (grinding). It has been modified
on the rear with a large drive gear and a gear box to turn the carriage very slowly. A grinding
spindle can be mounted on the carriage in order to perform the same function as it’s last use or
it can again be used as a hollow spindle lathe.
Yuasa hollow spindle lathe

 YUASA hollow spindle big bore lathe YUASA hollow spindle big bore lathe YUASA hollow spindle big bore lathe  YUASA hollow spindle big bore lathe